Get a smtp server ( i use mx1.hotmail.com)
they’re normally likemx1,mx2 etc..thehost.com.
Now, go to Start>Run>cmd then in the cmd window,
Type telnet mx1.hotmail.com 25
then HELO hotmail.com then MAIL FROM : (fake email here)
then RCPT TO: (person)then DATA then type your message,
you can press enter for a new line, finish the message by a full stop (.) on a new line, press enter!
spoofed.
For Educational purpose only
Subscribe to GeniusHackers via RSS
March 18th, 2008 at 5:09 am
i found this post to be usefull, so i linked it in my blog
http://blog.nftecnostar.com/nf-tecnostars-starred-links-2/
March 21st, 2008 at 5:54 am
iam not getting it , satish !
it says it does not allow dyanmic ips
March 23rd, 2008 at 3:15 am
Hi Arshad,
It does not mean dynamic ip’s means, you should have static IP of the victim to use this spoofing.
If you dont know anything about IP’s then Read on :
There are two types of IP’s
Static IP : which is always constant forr single internet connection on single PC.
Dynamic IP : Everytime you connect to internet this IP address changes , So it is dynamic IP address.
The Dynamic IP you have right now will be alloted to someone else when you disconnect Internet immediately.
So you can not spoof system with Dynamic IP’s.
You need static IP address for any intrusion in the system which is always constant.
March 28th, 2008 at 9:44 pm
Now thats cool